If you need options the guided form doesn't have, you can write the input file yourself.
Go to Quantum Chemistry → GAMESS, then the Use Your Own Files tab
(/gamess/submit/own).
| Program | Who can upload |
|---|---|
| GAMESS | Anyone who can submit jobs |
| Psi4, PySCF | Researcher accounts only (every verified .edu account), because the file runs as Python on the cluster. Student and workshop accounts can't |
A job from an uploaded file can bring back up to 5 GB of results in at most 10,000 files.
Tip: the easiest way to get a valid GAMESS input is to build the job in the guided
form, open Optional: Edit input file, and copy it as a starting point.
Uploaded GAMESS files fail far more often than guided jobs (about 4 in 10 against 1 in 7
on ChemCompute), and mostly for a few formatting reasons.
GAMESS only reads a group whose $ is in column 2: one space, then $CONTRL. A
group that starts in column 1 is silently skipped, so your settings vanish without an
error. This turns up in thousands of ChemCompute jobs.
$CONTRL SCFTYP=RHF RUNTYP=OPTIMIZE DFTTYP=B3LYP ICHARG=0 MULT=1 $END
$BASIS GBASIS=N31 NGAUSS=6 NDFUNC=1 $END
$DATA
Water
C1
O 8.0 0.0000 0.0000 0.1173
H 1.0 0.0000 0.7572 -0.4692
H 1.0 0.0000 -0.7572 -0.4692
$END
$ENDIncluding $DATA. A missing $END makes GAMESS read the next group as part of this one.
$DATA need a nuclear chargeEach atom line is label nuclear-charge x y z, e.g. O 8.0 0.0 0.0 0.0. An XYZ file
pasted straight in has no nuclear charge column, and GAMESS stops with
ERROR READING VARIABLE X CHECK COLUMN ….
Give the order of the main axis: CNV 2, not CNV (which gives
ILLEGAL POINT GROUP=CNV CHOSEN). After a point group other than C1, leave one blank
line before the atoms, and list only the symmetry-unique atoms. If in doubt, use C1
and list every atom.
=TYPING ERROR IN $CONTRL INPUT - CHECK NEAR $ MARKER means a misspelled keyword, a
missing =, or a keyword in the wrong group. GAMESS prints a $ under the spot it
didn't understand. Keep lines within 80 characters.
These follow the same rules as the guided form: ICHARG and MULT must fit the electron
count (see charge and multiplicity).
SCFTYP=RHF requires MULT=1. GBASIS=N31 (6-31G) covers only H–Kr, and N311 only
H–Ar (see basis sets).
If an optimization stops with FAILURE TO LOCATE STATIONARY POINT, TOO MANY STEPS TAKEN,
raise the step limit (e.g. $STATPT NSTEP=200 $END), or continue from where it stopped
with Do More Calculations on the results page.
Memory is set with $SYSTEM MWORDS=… $END (1 megaword = 8 MB). Each core you request
brings about 2 GB. If GAMESS says
MEMORY REQUEST EXCEEDS AVAILABLE MEMORY, ask for more cores or lower MWORDS. A
direct SCF ( $SCF DIRSCF=.TRUE. $END) saves disk space on large jobs.
When you continue a GAMESS job with Do More Calculations, lines you put after this
marker in the input file are carried into the new job:
! Customizations after this line are persisted when using Do More Calculations