Open the job's results page and read the Summary tab. It shows a diagnosis when the
job ends. For problems before the job runs, see
Why a job is refused.
About one NAMD job in seven ends with an error. Four in five of those fail while the
system is being built, before any dynamics runs.
ERROR(S) IN THE CONFIGURATION FILEThe output ends with FATAL ERROR: ERROR(S) IN THE CONFIGURATION FILE, and the Summary
says There was an error in setting up the simulation or
There was an error in setting up the box. NAMD never started: something in the system
couldn't be built or parameterized.
Things to check:
If none of these applies, open a support ticket with the job number:
some of these failures are problems on our side.
There are atoms in your structure that we don't have parameters forYour PDB entry contains a residue or ion that CHARMM36 doesn't cover and that couldn't be
parameterized. You'll see the same thing before submitting as
Unsupported residue(s)/ion(s) with no available parameters or
Could not generate parameters for: …. Choose a structure without it.
Atoms moving too fast; simulation has become unstableAlso Constraint failure; simulation has become unstable. The Summary suggests
Your atoms are moving too fast. Try decreasing your timestep (try 2 fs). The simulation
blew up, usually because atoms started out overlapping or too close.
Periodic cell has become too small for original patch gridUnder NPT the box shrank a lot, typically because the freshly packed water was less dense
than it should be, or a gas or vacuum gap collapsed. Restart from this job (Use Restart
File): NAMD sets the box up again at its new size. Or run a short NVT simulation first
and continue from that under NPT.
Error: job N has no restart files to continue from means the earlier job never got far
enough to write a restart file. Restart files appear once a run has started writing
output. You can only restart from your own NAMD jobs.
PDB not found in RCSB means there's no entry with that ID; check it at
rcsb.org. Could not download … from RCSB means the Protein Data
Bank didn't answer. Wait a few minutes and try again.
Your calculation went past the time limit means the job hit the limit you chose. Ask for
a longer limit, run fewer steps, or shrink the system: most atoms in a solvated system are
water, so a smaller box or padding speeds things up a lot. The results page offers to
resubmit with a longer limit.
Out-of-memory failures are rare for NAMD. If one happens, resubmit with more cores.
TINKER jobs rarely fail. When one does, the results page shows the last lines of TINKER's
output.
parameters line in.key file names the .prm file you uploaded, and that the atom types in your.xyz exist in it.Error: Invalid File: you must choose all three files (.xyz, .key and .prm).The minimization tolerance must be a number greater than 0 and no more than 1:0.01.